Rimage Producer III 6100 Benutzerhandbuch Seite 23

Rimage Producer™ III User Guide
c. If the disc is not centered front to back on the print pad, align the printer front to back by turning the front to back
alignment screw until the gap between the raised edge of the disc retainer and the disc is correct.
Everest: 0.063" gap at the front
Disc Retainer
Manually, slowly raise the lift arm away from the printer tray.
7.
8. Press the printer button. The printer tray closes.
9. Press the disc release button. The gripper releases the disc.
Tip: Place your hand under the disc to catch it.
10. Close the front door. The autoloader is ready for use.
22
7100N/8100N/6100N/6100
Prism: Disc hangs over the front edge of the print pad by
Gap
0.010" – 0.015"
Gap
Print Pad
2001475_A