Product Description; General Description; Initial Operation - Cleco 935391 Bedienungsanleitung

2

Product description

2 Product description
2.1

General description

• Automatic identification of connected battery.
• Automatic identification of a charged battery guarantees optimum charging results.
• Automatic identification of a defective battery.
• The recharging phase guarantees maximum run time of the battery.
• Charge status display
• Overcharge protection
• Wide-range input make worldwide use possible.
• Voltage monitor prevents deep discharging and battery short-circuits.
2.1.1 Display
LED
Power
Charge
Charge
Charge
3

Initial operation

WARNING!
Risk of explosion if other batteries are used
Use only to charge CLECO lithium ion batteries, order no. 935377.

Never use to charge other battery types.
The red Charge LED must not light up before the battery is plugged in.
When changing a battery, it may be necessary to wait a few seconds until the light goes out.

Once the battery is plugged in, the red Charge LED lights up,indicating that charging is in process.
When charging is finished, the charger automatically shuts off the charging process. The red Charge LED
goes out.
16
EN
Operating status
Continuous green light
Continuous red light
Continuous red light off
Flashing red light
P1893E/INT 2015-06
Result
Power supply connected
Battery being charged
Battery is charged
Defective or deep-discharged battery
Connect the charger to the power supply:

The green Power LED indicates that the power
supply is connected.
Plug the battery into the charger and ensure

that it is securely connected.
2069b_1_5_en_bedingt.fm, 22.06.2015