Sharp KF-76IDD19W-DE Bedienungsanleitung Seite 22

1- Zvogëlimi i kohë matësit
2- Treguesi i kohë matësit
3- Treguesi i zonës së kohë matësit
4- Selektimi i kohës
5- Koha e Rritjës
Përdorni zonat e gatimit me induksion
me enë gatimi të përshtatshme.
Pas përdorimit të tensionit të rrjetit,
pllaka është në modalitetin e
gatishmërisë dhe është gati për
funksionim.
Vatra kontrollohet nga përdorimi i
Use the corresponding knob to set the
cooking level from 0 to 9. The element
is now ready to use. For fast boil times,
keep the knob at the "P" position for 2
seconds to activate the Boost function
and then adjust to the desired level.
Switching the Cooking Zones Off
Adjust the knob to"0".
If the cooking zone is hot, "H" will be
displayed instead of "0".
Residual Heat Indicator
The residual heat indicator indicates
that the glass ceramic area has a
temperature that is dangerous to touch.
After switching off the cooking zone,
the respective display will show "H"
until the corresponding cooking zone
temperature is at a safe level.
Safety Switch-Off Function
A cooking zone will automatically switch
off if the heat setting has not been
modified for a specified duration of
time. A change in the heat setting of the
cooking zone will reset the time
duration to the initial value. This initial
value depends on the selected
temperature level, as shown below.
Heat setting
1-2
3-4
5
6-9
Safety switch off after
6 Hours
5 Hours
4 Hours
1.5 Hours
Timer Function
Cooking Zone Timer (1 - 99 min.)
When the hob is switched on, an
independent timer can be programmed
for each cooking zone.
Select a cooking zone, then select the
temperature setting and, finally,
activate the timer setting button
timer can be programmed to switch off
a cooking zone. Four LEDs are
arranged around the timer that indicate
which cooking zone the timer has been
set for.
10 seconds after the last operation, the
timer display will change to the timer
that will run out next (in cases where a
timer is set for more than one cooking
zone).
When the timer has run down, a signal
will sound, the timer display will show
´00` and the assigned cooking zone
timer LED will blink. The programmed
cooking zone will switch off and "H" will
be displayed if the cooking zone is hot.
The sound signal and the blinking of
the timer LED will stop automatically
after 2 minutes and/or by pressing any
button.
Buzzer
While the hob is in operation, the
following activities will be signalled by
the buzzer.
• Normal button activation will be
accompanied with a short sound
signal.
• Continuous button operation over
a longer period of time (10
seconds) will be accompanied with
a longer, intermittent sound signal.
EN -15
, the