Assembly Of The Head Adapter; Instructions For Use - aquatechnik BBR 90 Bedienungsanleitung

6.2 Assembly of the adapter head
1) Insert the conical pin in the centre of the hole and
screw the pin's locking screw up to the stop so that
the conical pin is fastened to the machine.
2) Complete the machine's stroke until it reaches the
starting position and tighten the adapter head up to
the stop, then tighten the safety screw until it stops.
3) The operation is completed. Ensure that the conical pin is adequately greased. Now assemble
the mechanical expander of the required diameter.
7

Instructions for use

1) Remove the conical pin protection (E) and set the mechanical expander (G) of the
desired working diameter on the Coupling tool BBR 90, checking that it has been
screwed up to the stop.
NB1: In order to perform this operation, the equipment must be in a rest position.
NB2: Check that the elastomeric adapter (G) is mounted on the mechanical expander (H) and
that no tears or breaks are evident on the elastomeric adapter.
The good shape of couplings is granted only if the adapter is in a good condition (for adapter
removal and replacement, see "Replacing of the elastomeric adapter").
Do not use grease, soap, lubricating or sliding
products of any kind on the elastomeric
adapter (H).
Warning: When mounting the mechanical expander,
make sure that the equipment is not connected to
the power supply source (battery or outlet).
2) Cut the pipe perpendicularly and with care, then insert the cap into it.
NB: To avoid damage to pipe heads, make sure that the shearing or pipe-cutting blades are in
good working order. blades are in good working order.
40
YES
ENGLISH
Picture 6
NO
Picture 4
Picture 5
STOP
Picture 7