Equipment Function; Changing The Battery A; Emergency Stop Button (B-1); To Switch On (B-2) - aquatechnik BBR 90 Bedienungsanleitung

3

Equipment function

3.1 Changing the battery
Insert battery until the catch clicks into place. (LED flashes briefly = Contact made). To remove
press the catch and take out the battery.
If the battery voltage is lower than necessary, the LED flashes red. Charge the battery in the
charger.
3.2 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the expanding process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and the
piston will return to its initial position.
3.3 To switch on
Press lightly the ON button, white LED's lights up for 30 sec.
Press the ON button until the expanding process has been completed. The motor cut out indicates
the end of the expanding cycle.
3.4 LED
The red LED can indicate the following:
Flashes red: Battery is flat. The current expanding process will be ended automatically. The
ON button will then be disabled and a new cycle can only be started once the battery has been
charged.
Lights up red: After 20.000 expanding cycles the LED lights up red after each expanding cycle
to indicate that the next inspection is due. An internal counter keeps a record of the number of
expanding since leaving the factory.
The white LED's lights up by starting the press cycle (up to 30 sec. after end of the expanding
cycle).
3.5 Battery/Charger
Mains connection:
Connect only to single-phase a.c. current and only to the system voltage indicated on the rating
plate. It is also possible to connect to sockets without an earthing contact as the design conforms
to safety class II.

Charging the battery:

ATTENTION! Overvoltage destroys the batteries and the charger. Observe correct
mains voltage.
The lithium-ion battery can be charged at every charging level and charging can be interrupted at
any time without damaging the battery (no memory effect).
 Insert mains plug of the battery charger into a mains power socket:
Red and green LEDs are lit.
 Connect the battery (1) to the battery charger (2):
Charging control lamp (3) flashes green: Battery is charged.
Charging control lamp (3) is lit green: Battery is fully charged. (For charging time, see
Technical Data).
 Keep button pressed and remove the battery.
 Disconnect mains power plug from the mains power socket.
Storage:
The place of storage must be inaccessible for children.
 Keep button pressed and remove the battery.
 Disconnect mains power plug from the mains power socket.
 Store battery charger in a dry, frost-proof place.
Store the battery only in a charged state! Fully recharge the battery after 12 months of
ENGLISH
A
B-1
B-2
C
D
37