MORIA 65114 Benutzerhandbuch Seite 5

Table 3 - Guidance and manufacturer's declaration – electromagnetic immunity – for ME equipment
and ME systems that are not life-supporting
ACP system is intended for use in the electromagnetic environment specified below. The customer or the user of ACP system should
assure that it is used in such an electromagnetic environment.
Immunity test
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
Proximity fields from RF
wireless communications
equipment
(1) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the
electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured
field strength in the location in which ACP system is used exceeds the applicable RF compliance level above, ACP system should
be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-
orienting or relocating ACP system.
(2) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
3
MORIA #65114-C-04.2017
Guidance and manufacturer's declaration – electromagnetic immunity
Immunity test
3 Vrms outside ISM band
6 Vrms in the ISM band
150 kHz to 80 MHz
3 V/m
80 MHz to 2,7 GHz
27 V/m for 385 MHz band
28 V/m for 450 MHz band
9 V/m for 710, 745, 780 MHz band
28 V/m for 810, 870, 930 MHz band
28 V/m for 1720, 1845, 1970 MHz band
28 V/m for 2450 MHz band
9 V/m for 5240, 5500, 5785 MHz band
Immunity test
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey
(1), should be less than the compliance level in
each frequency range (2).
Interference may occur in the vicinity of
equipment marked with the following symbol: