Annex - User Manual Acp System; Guidance And Manufacturer's Declaration - MORIA 65114 Benutzerhandbuch

WARNING AGAINST ELECTROMAGNETIC COMPATIBILITY (EMC)
ACP system needs special precautions regarding EMC.
ACP system has to be installed and put into service according to the EMC requirements.
ACP system can be affected by portable and mobile RF communications.
WARNING: Use of this equipment adjacent to or stacked with other equipment should be avoided because it could
result in improper operation. If such use is necessary, this equipment and the other equipment should be observed to
verify that they are operating normally.
WARNING AGAINST ELECTROSTATIC DISCHARGES (ESD)
Pins of connectors identified with the ESD warning symbol should not be touched and connections of these connectors
should not be made unless ESD precautionary procedures are used.
When a cable is connected to a connector identified with the ESD warning symbol, ACP system shall be switched off.
Then, touch the main earth terminal or metal part which is connected the earth in order to unload your body and
connected the wished cable. Follow the starting procedure (refer to user manual #65112).
All staff involved must receive an explanation of the ESD warning symbol and a training in ESD precautionary procedure.
The training's content must include:
• the introduction of ESD warning
• a practical example of cable connection when ESD warning is present
• the insurance that the staff has completely understood the procedure and the risk if the staff doesn't apply it.
WARNING AGAINST INTERFERENCE RISK
Use of accessories, transducers and cables other than those specified or provided by the manufacturer of this
equipment could result in increased electromagnetic emissions or decreased electromagnetic immunity of this
equipment and result in improper operation.
ACP system should not be used adjacent to or stacked with other equipment and that if adjacent or stacked use is
necessary, ACP system should be observed to verify normal operation in the configuration in which it will be used.
Portable RF communications equipment (including peripherals such as antenna cables and external antennas) should
be used no closer than 30 cm (12 inches) to any part of ACP system, including cables specified by the manufacturer.
Otherwise, degradation of the performance of this equipment could result.
1
MORIA #65114-C-04.2017

ANNEX - USER MANUAL ACP SYSTEM

Guidance and manufacturer's declaration :

electromagnetic emissions
electromagnetic immunity
recommended separation distances