Installation - FILL-RITE FR1200C Gebrauchsaneisung Und Sicherheitsvorschriften

For Skid Mounted Tanks
Follow steps 1 through 4 on Page 1.
A. Pass the electrical wires to the power source, supporting the
wires as necessary and protecting them from sharp edges, heat
and anything that could damage the wires.
B. Attach one end of the fuse holder to the brown pump wire. Make
a solid electrical connection to the positive terminal of the power
source with the other end of the fuse holder. Make a solid
connection with the blue pump wire to the negative terminal of
the power source.
C. Check all connections to make sure they are connected per
instructions and all electrical codes. Install the 30 amp slow blow
fuse in the fuse holder. The installation is now complete.
FR1200C
FR4200C
IF PUMP FAILS TO PRIME:
Check suction line for leaks or obstructions. Check bypass valve
for dirt. The poppet should slide freely.
PUMP IS BOUND:
If the motor hums but will not start, the probable cause is a stuck
rotor. Remove rotor cover and check rotor and vanes for dirt.
MATERIALS OF CONSTRUCTION
Materials of construction of the external surface of the unit are: painted
steel; painted cast iron; painted aluminum; zinc plated steel.
Materials of construction of the wetted parts are: cast iron; steel; zinc
plated steel; 300 series stainless steel; bronze; carbon;
ceramic; polyester; acetal; fiber; fluorocarbon; buna; cork/buna.
REPAIR AND MAINTENANCE
Contact the place of purchase for warranty repair and maintenance.
SPECIAL CONDITIONS FOR SAFE USE
An electrically conductive hose and nozzle must be used with
flammable liquids. To minimize static electricity built-up, keep nozzle in
contact with container being filled.

INSTALLATION

Pump must be installed in compliance with EN 60079-14.
TROUBLESHOOTING (ALL PUMPS)
LOW PUMPING CAPACITY:
2
FR2400C
FR4400C
Strainer screen clogged, bypass valve not seating properly,
obstruction in suction lines. Make sure all 5 vanes slide easily in their
slots.