Troubleshooting - Suntec Wellness KLIMATRONIC PROGRESS 9.000 Eco R290 Bedienungsanleitung

Full") lights up. Please let the water drain through the drain hose and then remove the hose.
Close the rubber blockage of the drainage hole.
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and neutral detergent and then wipe dry
with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks with neutral detergent and lukewarm water, then let it air-dry
before inserting it back into the unit.

Troubleshooting

Problem
1. Unit does not start
when pressing
"POWER".
2. It's not cool
enough.
3. Unit is too loud.
4. E0 Code
5. E2 Code
Possible causes
Water tank is full and indicating light
"W.F." is blinking.
Room temperature is lower than the set
temperature during operation mode
cooling.
Doors or windows are not closed.
There are heat sources in the room.
Exhaust hose is not installed or blocked.
Set temperature is too high.
Air inlet is blocked.
The ground is not even and flat enough
The sound comes from the flowing of
the refrigerant inside the unit.
Room temperature sensor is not
functioning.
Water tank is full.
Suggestions
Empty the water tank.
Reset the temperature.
Close all doors and windows.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Reset the temperature.
Clean the air inlet
Place the unit on an even and flat surface.
None, this sound is normal.
Let the sensor be replaced by your
vendor. The unit can also work without a
new sensor.
Empty the water tank.