Turning Power On/Off; Turning On The Main Power - Sharp PN-40TC1 Installationsanleitung

Caution
• When all connections are complete, turn on the power.
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.

Turning on the main power

Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
Status
Green lit
Orange lit
Green flashing
TIPS
• When the main power switch is off, the monitor cannot be
turned on.
Turning Power On/Off
POWER button
TOUCH
MENU
Power LED
Status of the monitor
Power on
Power off (Standby mode)
Input signal waiting mode
nMode setting
When the monitor is turned on for the first time after being
shipped from the factory, the mode setting screen will be
displayed.
(1) Press the or button to select YES or NO.
(2) Press the ENTER button.
YES:
• OPERATION MODE is set to MODE1.
• OFF IF NO OPERATION is set to ON, and POWER
SAVE MODE is set to ON. (These settings can not be
changed.)
• If there is no operation for 4 hours or more, the monitor
automatically enters standby mode.
• Compared to when set to OFF, the current consumption
is reduced while the monitor is in standby mode, but the
startup time from standby mode becomes longer.
• While the monitor is in standby mode, control via LAN
will be disabled.
NO:
• OPERATION MODE is set to MODE2.
• OFF IF NO OPERATION is set to OFF, and POWER
SAVE MODE is set to OFF. (These settings can be
changed.)
• Compared to when set to ON, the startup time from
standby mode is reduced, but more power will be
consumed in standby mode.
Even after being set, changes can be made using
OPERATION MODE, located in MONITOR menu.
7
E