Troubleshooting - Pioneer PD-F1009 Bedienungsanleitung

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check
the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being
used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or
your dealer to carry out repair work.
Symptom
No sound • Output cables are connected incorrectly or
• Incorrect operation of stereo amplifier.
• Pin plugs and/or amplifier terminals are dirty.
• Player is in pause mode.
• The disc is loaded with the label side leftward.
When playback is started, • Disc is inserted in the wrong way.
it stops immediately.
Pauses or stops during • Smudges, etc., on the disc.
playback.
Remote control will not • Dead batteries.
function. • Obstruction between player and remote control
Abnormal functioning of this unit may be caused by static electricity, or other external interference. To restore normal operation unplug
the AC power cord and then plug it in again.
SELF-DIAGNOSTICS FUNCTION
The unit incorporates the self-diagnostic function.
When an abnormality is detected during operation of the unit, an error message (service No.) appears on the unit's display automatically.
Treat the error by following the instructions in "Countermeasures".
Display on the unit
Service No.
Service No.
U1
U2
U3
If the same display appears again, there may be an error in the mechanical section. When requesting servicing, please also let us
know the service number displayed on the unit.
Cause
loosely.
unit.
DISC
Unit Status
The disc may not be loaded properly in the
rack.
There is an operation error in the mechanical
section.
There is an error related to the hood.
• Connect properly.
• Check the settings of amplifier switches and
sound volume controls.
• Clean away dirt.
• Press 3 or 8.
• Reload the disc with the label side rightward.
• Insert the disc correctly with the label side
leftward.
• Clean the smudges from the disc and then
play it again.
• Replace batteries.
• Relocate remote control unit or remove
obstruction.
TRACK MIN SEC
• Reload the discs properly.
(Insert only one disc in a slot.)
• Check if there is a foreign object attached onto
the disc.
• Check if there is a foreign object in the rack.
• Check if there is a foreign object in the rack.
• Unplug the power cord then plug it in again.
• Check if the hood is caught by anything.
• Unplug the power cord then plug it in again.
Remedy
Countermeasures
29
En