Printer Requirements; Label Design Requirements - Rimage 2000i Series II Handbuch

Printer Requirements

This section describes the ink, label design, and print requirements for the
Rimage 2000i.
Ink Requirements
Important!
Use only authentic Rimage ink cartridges in the Rimage 2000i.
•
Keep print cartridges sealed in their original packaging until they are
•
needed.
Do not use ink cartridges that have expired.
•
Store print cartridges at room temperature
•
Store print cartridges in an upright position, not on their sides or upside
•
down.
Do not remove the protective tape from a new print cartridge until
•
immediately before installation. After you remove the tape, do not reapply
it.
After you have removed the protective tape, do not touch the contacts and
•
nozzles.
Print discs at least once a month to keep the print cartridges in good
•
working order.
The Rimage 2000i will work only with the following printer cartridges:
Description Rimage Part Number
Black RB1
Color RC1
The following cartridge combinations are supported on the Rimage 2000i
printer:
Left Position
Color
Color
No cartridge
2002760_A
(60° to 78° F / 15.6°
203340-001
203339-001
Right Position
Black
No cartridge
Black
For more information visit

Label Design Requirements

The Rimage 2000i Software includes a label editor called CD Designer™,
which is installed on your PC during a typical installation of the Rimage 2000i
Software. You can use CD Designer to design your disc labels.
If you prefer to design labels in a software application other than CD
Designer, use the following criteria:
• File format: For best results, save your labels as JPEG or TIFF files.
However, these file formats must be converted before printing. If you
use CD Designer to print labels, you must import the labels and save
to 26.6° C).
them as CD Designer files (.btw) before printing. If you do not use CD
Designer to print labels, you must convert the labels to PDF files before
printing.
• Color mode: Labels imported into CD Designer must be in RGB color
mode.
• Resolution (pixels per inch): For best results, use images set to a
minimum of 300 pixels per inch.
• Label design size: Design labels with a
height of 12 cm and a width of 12 cm.
A full-size disc is 120 mm (4.723") in
diameter. The hole is 15 mm (0.59"). The
printable area and hub sizes may vary
between disc manufacturers.
Note: The media in Rimage Media Kits have a
printable area of 118 to 24 mm. On most
labels, print settings of 118 mm and 24 mm
are recommended. Refer to the image.
Print Requirements
All labels created and saved through CD Designer are in the correct file
format (.btw) for printing with the Rimage 2000i. If you are creating and
saving labels with a software application other than CD Designer, save your
labels as PDF files before printing with the Rimage 2000i.
rimage.com/support
Printable Area
118 mm
Hub Size
24 mm
5