Rimage 2000i Series II Handbuch Seite 17

Maintain the Rimage 2000i Series II
Materials Task
Mandatory, continued
New fan filter Replace the fan filter. Refer
to the Replace the Fan Filter
instructions on page 16.
Can of Remove dust from the system.
compressed air Refer to the
the Rimage 2000i
Torx T10
page 14.
screwdriver
New ink Replace the ink cartridges. Refer
Replace the Ink Cartridges
cartridges to the
instructions on page 16.
Optional
None needed Clean the ink cartridges. Refer
Clean the Ink Cartridges
to the
instructions on page 16.
Align the printer. Refer to the
Torx T25
Align the Printer
screwdriver
page 18.
11/32" nut
driver
5/32" Allen
wrench
Remove Dust from the Rimage 2000i
# Required tools:
Can of compressed air
•
Torx T10 screwdriver
•
1. Press the recorder buttons to open the recorder trays.
2002760_A
Frequency
Monthly
Monthly
Remove Dust from
instructions on
As needed
When print
quality problems
are noticed
As needed
instructions on
Note: The printer
is aligned at the
factory.
For more information visit
2. Power off the Rimage 2000i.
3. Disconnect the cables from the back of the system.
Caution: Some cables in this system are latched. Equipment damage
n
may occur if cables are not disconnected appropriately.
• Power cord
• USB cable
4. Remove the back panel.
a. Remove the Torx T10
screws (Qty. 6) that
secure the back panel.
b. While firmly grasping
the top of the back
panel, lift and pull back
to remove it.
5. Slide the left side panel
straight back and off of
the system.
rimage.com/support
Back Panel
USB Cable
Power Cord
Left Side
Panel
14