Rimage 2000i Series II Handbuch Seite 22

Maintain the Rimage 2000i Series II
f. Place a disc (Qty. 1) on the printer tray so that the two small pins are
aligned at the front of the hole in the disc, and the disc lays flat on
the printer tray. Refer to the images below.
g. Press the operator button. The lift arm picks up the disc.
h. Press the operator button again. The lift arm releases the disc onto
the printer tray.
• If the printer is properly aligned, the lift arm smoothly sets the
disc onto the printer tray, and the disc sits on the printer tray as
shown in the photos above
The two small pins are aligned at the front of the hole in the
ƒ
disc.
The disc lays flat on the printer tray.
ƒ
• If the disc is seated on the printer tray as shown above, the
printer is aligned. Remove the disc from the printer tray and
continue to step 9.
• If the disc is not seated on the printer tray as shown above, you
must align the printer. Continue to step 4.
2002760_A
4. Access the printer.
For more information visit rimage.com/support
a. Open the printer service door to access the hex nuts at the rear of
the printer.
Note: You may need to prop this door open or have someone hold
the door for you.
b. With the 11/32" nut driver, loosen the hex nuts (Qty. 2) at the rear
of the printer. The printer frame loosens, allowing you to use the
alignment screws (Qty. 3) to align the printer in step 6.
Note: The purpose of the hex nuts is to hold the printer securely
during shipment. Tightening these nuts after alignment is optional.
c. Close the printer service door.
Hex Nuts
19