Rimage 2000i Series II Handbuch Seite 18

Maintain the Rimage 2000i Series II
6. Remove the dust.
a. Spray the compressed air through the recorders from front to back.
b. Open the ink cartridge access door.
c. Spray the compressed air through the printer from front to back.
d. Open the printer access door.
e. Spray the compressed air from the hinges of the printer access door
to the back of the system.
Air Flow
2002760_A
Ink Cartridge
Access Door
Air Flow
Printer
Access Door
For more information visit
f. Spray the compressed air from the front to the back of the system,
across the USB hub and the power supply.
7. Slide the left side panel into place.
8. Position the back panel on the system.
9. Install and tighten the Torx T10 screws (Qty. 6) to secure the back
panel.
10. Connect the cables at the back of the system.
• Power cord.
• USB cable
11. Power on the Rimage 2000i.
12. Press the recorder buttons to close the recorder trays.
rimage.com/support
Air Flow
15