Operation - Worx Professional WU700.1 Bedienungsanleitung

2
GRINDING/CUTTING DISC
Pay attention to the dimensions of the grinding disc. The
mounting hole diameter must fit the inner flange (6) without
play. Do not use reducers or adapters.
When using a diamond cutting disc, take care that the direction-of-
rotation arrow on the diamond cutting disc and the direction of rotation
of the machine (direction-of-rotation arrow on the machine head)
agree.
For mounting, see the Component list illustration page.
Screw on the outer flange (5) and tighten with the two-pin spanner (9).
(See Fig. B)
3
ADjUSTABle OUTeR FlANGe ClAMPING
The outer flange (5) should be adjusted to suit different disc thickness.
For thinner cutting or diamond discs the raised part of the outer flange
is fitted facing away from the disc (See Fig. C.2). For thicker grinding
discs the raised part of the outer flange is fitted facing towards the
disc to provide improved support for the disc hole (See Fig. C.1).
Always ensure your disc is securely clamped.
ADjUSTING THe PROTeCTION GUARD
Before any work on the machine itself, pull the mains plug.
For work with grinding or cutting discs, the protection guard
must be mounted.
The coded projection (12) on the protection guard (10/13) ensures that
only a guard that fits the machine type can be mounted.
Loosen the clamping screw (11), if necessary.
Place the protection guard (10/13) with coded projection (12) into the
coded groove on the spindle collar of the machine head and rotate to
the required position (working position).
The closed side of the protection guard (10/13) must always
point to the operator.
Tighten clamping screw (11).

Operation

STARTING OPeRATION
To start the power tool, push the on/off switch (1) forward.
To lock the on/off switch (1), press the on/off switch (1) down at the
front until it engages.
To switch off the power tool, release the on/off switch (1) or, if it is
locked, briefly push down the back of the on/off switch (1) and then
release it. (See Fig. D)
OPeRATING INSTRUCTIONS
•
Clamp the workpiece if it does not remain stationary due to its own
weight.
• Do not strain the machine so heavily that it comes to a standstill.
• Grinding and cutting discs become very hot while working; do not
touch until they have cooled.
• Pull the plug from the socket-outlet when not using the machine.
With the plug inserted and mains voltage existing, the power tool still
has low power consumption even when it switched off.
1
HAND GRIP AReAS
Always hold your angle grinder firmly with both hands when operating
(See Fig. E).
2
ROUGH GRINDING
The best roughing results are achieved when setting the machine
11