10
Application
7
Application
Caution!
General danger with risk of injury
Do not operate the Sterisart
installed . The pump may only be operated with the tubing inserted and only by
one person at a time . Never pump any flammable, corrosive or explosive fluids .
Users should always wear tight-fitting clothing (no ties, etc .) .
To be able to operate the pump, Sterisart
beforehand . To do this, follow the steps given below:
Remove the sterility test systems from their respective packaging and place the steril-
ity test sample containers in the container for draining on the right side of the pump .
– Now open the lever and the bow .
– Keep the tubing around the rotor of the pump (the arrow on the fixed part sur-
rounding the pump head indicates the subsequent direction of rotation), so that no
kinks occur and the tubing is not under tension (Fig . 3) . The tubing is attached by
simply inserting it (with it lying on the ground) and fastening the lever (Fig . 4) . In
this way, the tubing is automatically correctly positioned .
Important Note!
When threading the tubing, make sure that it is not kinked or twisted .
Fig . 3
– To start the pumping process, the tubing must be fully inserted and the lever
must be engaged . A safety function ensures that the pump does not start if the
lever or the bow are open .
®
Universal pump until the tubing has been properly
®
sterility test systems must be installed