Timer; Set; How To Use - Panasonic CS-E9GFEW Bedienungsanleitung

How to use

MODE
To select operation mode
AUTO - For your convenience
• During operation mode selection the POWER
indicator blinks.
• Unit selects operation mode every
Single
10 minutes according to setting
temperature and room temperature.
• Unit selects operation mode every 3
Multi
hours according to setting temperature,
outdoor temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
POWERFUL
To reach temperature quickly
POWERFUL
• This operation stops automatically after
Single
20 minutes.
• Press the button again or turn OFF the
Multi
unit to stop this operation.
QUIET
To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
To adjust horizontal airfl ow direction
Note
POWERFUL QUIET
,
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
• Cannot be selected at the same time.
6
• Both upper and lower
horizontal airfl ow
direction louvers are
manually adjustable.
(Green)
(Orange)
(Orange)
Remote control display
FAN FAN
AUTO AUTO
SPEED SPEED
HEAT HEAT
COOL COOL
DRY DRY
OFF OFF
OFF OFF ON ON

TIMER

TIMER TIMER TIMER
OFF/ON OFF/ON
FAN SPEED
MODE
POWERFUL
AUTO
TEMP TEMP
AIR SWING
QUIET
MANUAL
TIMER TIMER
ON ON

SET

SET
1 1 2 2 3 3
OFF OFF CANCEL CANCEL
CHECK CHECK CLOCK CLOCK RESET RESET
Auto OFF/ON button
Use when remote control is
misplaced or a malfunction occurs.
1. Press the button once to use in
AUTO mode.
2. Press and hold the button until
you hear 1 beep, then release to
use in forced COOL mode.
3. Repeat step 2. Press and hold
the button until you hear 2 beeps,
then release to use in normal
COOL mode.
4. Repeat step 3. Press and hold
the button until you hear 3 beeps,
then release to use in forced
HEAT mode.
• Press the button again to turn off.
Single split system
Single
Multi split system
Multi
(Orange)
(Orange)
Indicator
Press and hold for
approximately 10
seconds to show 12-hour
(am/pm) or 24-hour time
indication.
Press to restore the
remote control to
default setting.