Nice Robus 600 Bedienungsanleitung Seite 19

LAST 8 MANOEUVRES
AUTOMATIC OPENING
Diagnosis 1 - OUT
GENERAL DATA:
Stand-by
POWER SUPPLY:
MEMORY ERROR:
Rego
Functions
Alt
Bluebus
Positions
ENCODER STATUS:
Abs M1
OUTPUTS:
Suction cup Out
Out 1
Out 2
Out M1
ALARMS:
Out 1 overload
Out 2 overload
M1 high overtravel
other parameters
This function enables display of the operating status of some parameters measured by the control unit. These parameters are
described in Table 5.
PARAMETER
Diagnostics 2
VARIOUS PARAMETERS:
Courtesy light
Pause time
Temperature
Level 2: THRESHOLD 1; the manoeuvre is started with a 2 second
delay;
Level 3: THRESHOLD 2; the manoeuvre is started with a 5 second
delay;
Level 4: MOTOR ALARM; the manoeuvre is only enabled with the
hold-to-run control.
Indicates any malfunctions occurring during normal operation of the
application, showing the last 8 manoeuvres completed.
Indicates if this function is active.
Indicates when the automation is in the standby status.
Indicates the type of electrical mains used by the automation: electric
mains (120/230 Vac) or buffer battery (24 Vdc)
Indicates whether there is an error in the memorised data on the con-
trol unit regarding settable parameters.
Indicates whether there is an error in the memorised data regarding
the functions programmable with Oview.
Indicates whether there is an error in the memorised data regarding
the configuration of the alt input.
Indicates whether there is an error in the memorised data regarding
the configuration of the devices connected to the bluebus input.
Indicates whether there is an error in the memorised data regarding
positions.
Indicates whether there is a reading error or operating malfunction on
the absolute encoder of motor 1.
Indicates when the suction cup is active.
Indicates when output 1 is active. Caution – 12/24 Vdc voltage present.
Indicates when output 2 is active. Caution – 24 Vdc voltage present.
Indicates when motor 1 is in operation.
Indicates an electrical overload or short circuit on output 1 or on the
courtesy light of the control unit.
Indicates an electrical overload or short circuit on output 2.
Indicates that the absolute encoder of motor 1 is in a position close to
the maximum limit (100%), over which the motor does not function.
TABLE 5: DIAGNOSTICS of other parameters
DESCRIPTION
Indicates the timer for shutoff of the courtesy light.
Indicates the timer for counting the pause time between one
manoeuvre and the next.
Indicates the temperature of the motor, measured by the control unit.
Robus 600-1000 – 19