Werbung
Tip
lf you want to make orange juice for refreshment, you just
need to peel the oranges and put them into the juicer.
lf possible, put the oranges into a refrigerator for a while
before juicing.
Assembling the appliance
DANGER - Risk of injury
The filter has small, very sharp knives in it which chop up the
food to be juiced. Be very careful when putting in the filter.
Risk of injury!
1. Place the base and motor on a stable and even surface.
Ensure that the surface cleans easily and wipes well.
2. Place the filter holder on the base.
3. Put the stainless steel filter into the filter holder. Push
down on the edge of the filter and slightly turn backwards
and forwards until you feel and hear the filter snap into
place.
It is mandatory that the filter is properly seated on the
motor's drive shaft!
4. Put the lid onto the filter holder.
5. Lift up both clamps and clamp them onto the fasteners
located on the lid.
6. Place the pusher on the chute.
7. Place the pulp collector under the pulp guard.
Juicing
DANGER - Risk of injury
The pusher must be left in the chute while juicing. Never put
your fingers or any objects into the chute.
ATTENTION - Material damage
- Avoid putting too much food into the juicer or to exert too
much pressure on the motor by pushing down on the pusher
too hard.
- The appliance is not designed for continuous operation.
Allow the motor to cool down after 2 minutes of uninter-
rupted operation.
- Before every use, check if the juicer and all its parts are
properly and completely assembled. Otherwise, the
appliance will refuse to start.
1. Put the prepared food into the order in which you wish to
process it and place a suitable, sufficiently sized receptacle
under the spout.
2. Check that all parts of the juicer are correctly and firmly
assembled and that the M/O/1/2 switch is set to O.
3. Insert the power cord plug into a socket and start the
appliance by turning the control knob to level 1 or 2
depending on your needs (see the table "Recommended
speeds"). The motor will start to run.
4. Pull the pusher out of the chute and fill the prepared food
into the chute.
5. Slide the pusher into the chute and push down slightly to
propel the food towards the juice receptacle.
PULSE FUNCTION
Turn and hold the control knob to "PULSE" to operate the
appliance at maximum speed. Release the knob to stop the
appliance.
Note
To maintain perfect performance of the juicer, prevent the
pulp collector from becoming too full. Empty the collector as
necessary (see next section).
Emptying the pulp collector during operation
You can empty the pulp collector during operation.
1. Turn off the appliance (M/0/1/2 switch to O) and unplug
from the wall outlet.
2. Slightly tilt the pulp collector away to one side and carefully
pull it out from under the pulp guard.
3. Empty the pulp collector, put it back into place, and restart
the juicer as appropriate.
Placing a plastic bag in the pulp collector
To make the pulp collector easier to clean, try putting a small
plastic bag into the collector bowl. This will also avoid the
pulp in the bowl squirting out at the sides of the bowl.
After use
1. Turn off the appliance (M/O/1/2 switch to O) and unplug
from the wall outlet.
2. Empty the pulp collector or remove the plastic bag.
3. Disassemble and clean all parts of the appliance.
Cleaning
DANGER - Risk of injury
- Unplug the appliance before cleaning.
- Do not immerse juicer in water or other liquids. Electric
shock hazard!
- Prior to disassembling and cleaning the appliance, unplug
the unit from the wall outlet.
- The filter has small, very sharp knives in it which chop up the
food to be juiced. Take greatest care not to injure yourself
when removing or cleaning the filter. Risk of injury!
ATTENTION - Material damage
Do not put the juicer or any of its accessories into
a dishwasher.
15
Werbung
