Ac Current Measurement - HT HT4010 Bedienungsanleitung

4.3.3 AC Current measurement

Make sure that all the test leads are disconnected from the meter terminals
for current measurement.
1. Rotate the switch on position on a measurement range between 2A
the current value under test is unknown, select the highest range
Put the conductor to be tested inside to the clamp jaw (see
2. Fig. 4), then the current value is shown at display
3. "OL" message is shown at display the current under test is over the maximum value
that the instrument is able to measure
4. For HOLD and MAX functions please refer to paragraph 4.2
Fig. 4: Taking AC current measurement
EN - 11
CAUTION
HT4010
and 600A . If