OHAUS RANGER 3000 Bedienungsanleitung Seite 4

EN-2
SETUP
A) The OHAUS Interface is preset to communicate using the following settings: 9600 baud, 8 bit,
no parity, no handshake. Determine the RS232 parameters required for the printer or computer
that is to be connected. See computer or printer documentation if assistance is required. If the
parameters do not match, it will be necessary to change either the scale's settings, or the
computer / printer settings.
B) Upon installation of the interface, the scale will recognize the RS232 Interface and add relevant
items to the menu. Configure the scale to the desired RS232 and printing parameters; refer to
the scale User Manual for assistance in using the menus.
PRINT2
Reset
Stable Only
On, Off
A.Print
off, On.Stbl, Int, cont, Acc
Content
Layout
Data.Tr
End
SETUP DEFINITIONS
PRINT / Stable - On
PRINT / Auto Print – Continuous
PRINT / Auto Print – On Stable
PRINT / Auto Print – (xx) sec
PRINT / Auto Print – Off
COM / Baud, Parity, Handshake
CONNECTION
The RS232 Interface Kit cable terminates with a 3 pin Sub-D female connector.
Active pins: Pin 1 = Ground, Pin 2 = RXD, Pin 3 = TXD
The Interface connector will connect directly to a computer, an Ohaus printer and many other
printers.
COM2
Reset
Baud Rate
600, 1200, 2400, 4800, 9600, 19200
Parity
7-even, 7-odd, 7-none, 8-none
Stop bit
1, 2
Handshake
None, Xon-Xoff
End
Balance transmits stable data only.
Balance repeatedly sends data as fast as possible.
Balance automatically outputs data upon stability.
Balance sends data every (xx) seconds.
Only sends data when PRINT is pressed.
Set parameters to match printer or computer.
RS232 Interface