Operation; Preset Recall; Pitch Wheel; Modulation Wheel - Studiologic acuna88 Bedienungsanleitung

To recall a preset, turn Data Entry. There are 50 presets availa-
ble which you can overwrite with your own settings. To scroll
through a wide range of preset numbers just turn Data Entry
more quickly. In this way it is possible to change from P01 to P50
with a quick half turn of the encoder. To perform a preset change
in steps of 1 turn Data Entry slowly. Right after selection the
preset is active and its name and number are shown in the first
row of the display.
To vary the pitch while playing use the Pitch wheel on the
left. Depending on the attached sound module or software
instrument, changes from a few semitones to several octaves are
possible. The wheel is self centering and will go back to its center
position after being released (i.e. no pitch applied).
The Modulation wheel can control any of the 128 MIDI Control
Change parameters. For each zone a different MIDI CC is assigna-
ble. Please refer to page 11
Press Control 1 to Control 4 to switch the respective zone on or
off.
If a zone is active its blue LED lights up. If a zone is predefined
but not active at the moment, the LED is blinking (please refer
to page 10 Status "Stand-by"). A zone cannot be used in the
F
current preset, if its LED is off (neither blinking, nor lit up).
To change MIDI parameter, turn Control 1 to Control 4. The
current value of each encoder is shown in the second row of
the display. As long as you turn an encoder the first row shows
the assigned MIDI CC number.
You can quickly assign to Control 1 to 4 four pre-defined MIDI
parameters. Press and hold Control 1 for 2 seconds. The first row
of the display now shows Set Control. Turn Control 1 to select
one of the MIDI parameters Volume, Program Change or from
two freely assignable MIDI CC (please refer to page 13
Func4). Press Control 1 another time to exit this quick assign
page. The quick assign of Controls 2, 3 and 4 is performed the
same way.
Each controller can be freely assigned to each zone. On the left
of the first row of the display the zone assignment is shown by
inverse coloured numbers. If the display shows 1111, all Controls
1 to 4 are assigned to zone 1. If the display shows for example
1142, Control 1 and 2 are assigned to zone 1, whereas Control 3
is assigned to zone 4 and Control 4 to zone 2.
The zone assignment of the controller is described on page 13
Zone.
F
Modulation.
F

Preset recall

Control 1 Control 2

Pitch wheel

Modulation wheel

Switch zones on / off
Control 1 Control 2

MIDI controller

Control 1 Control 2
Func3,
F
acuna88 by Studiologic®

Operation

Data Entry
+
-
Edit
Control 3 Control 4
Data Entry
+
-
Edit
Control 3 Control 4
Data Entry
+
-
Edit
Control 3 Control 4
9
E