Putting The Remote Control Into Service; Fitting Batteries; Initial Pairing - Zehnder 40019309 Bedienungsanleitung

IMPORTANT This radiator is equipped with a resistance which has an integrated power shut-
off and fuse. Using the radiator without water will permanently damage the fuse as well as
the resistance. In this case it must be changed though "not under the manufacturer's gua-
rantee
off automatically. Alternate function will continue as long as the main heating section is not
If you notice that the electrical part of your towel dryer is activated, but that it fails to heat up
1) Ascertain that your radiator is full of water (see paragraph B).
safety device.
52
chapter 5.1) to stop the electrical
40019121

4. Putting the remote control into service

4.1 Fitting batteries

mode

4.2 Initial pairing

Essential procedure Make sure you only
when you first turn pair one appliance
the appliance on" and one remote
control at a time.
LED:
it on the wall, or else use a small mirror.
The first time the appliance is turned on, the LED turns on as a steady
pink light, to show that pairing has not yet been done (see chapter 4.3).
SENSOR
( LED)
CLIC x 2
02/2019
boost
mode
mode mode
When pairing an appliance fitted
with a radio-frequency remote
control, all the other radiators in
the facility must be turned on.
WARNING
The appearance of the
LED may vary according
to the appliance model
(see cover page 3).
boost
mode
53