Faults; Repair; Disposal - Simco Meb Bedienungsanleitung

9. Faults

Problem
No/poor ionisation.
No high voltage on emitter
points.
Table 1: faults
10 Repairs
Warning:
− When carrying out work on the equipment: de-energise the equipment.
The anti-static bar does not comprise any parts which can be replaced by client.
SIMCO recommends that you return the bar if repairs are required.
Request an RMA form by sending an e-mail to service
Pack the bar properly and clearly state the reason for return.

11. Disposal

Adhere to the applicable local environmental and other rules when disposing of the equipment.
Staven 97.52.03.90.10
Cause
No high voltage.
Anti-static bar is fouled.
Emitter points are
damaged.
Emitter points are covered. Remove the cover.
High voltage power unit is
defective.
Short circuit in the HV
cable or anti-static bar.
17
Remedy
Restore high voltage.
Clean anti-static bar.
Return bar for repair.
Repair high voltage power
unit.
Eliminate short circuit or
return the bar for repair.
simco.nl.
@
08/08