OHAUS TD52 Bedienungsanleitung Seite 12

EN-10
Ethernet Connection
If DHCP is set to ON, the IP Address will be automatically assigned by the IP share or router. If the
DHCP is set to OFF, the user can setup the IP Address, Subnet mask, Gateway, Preferred DNS and
Alternate DNS. The Interface has a preset IP Address. The Port Number is always 9761 and cannot
be changed.
Note: After the setup of IP Address, Gateway, Preferred DNS and Alternate DNS, please reboot the
indicator to enable the setting.
OPERATION
Output
With the interface installed the indicator will operate in one of the following two ways:

Auto Print = off, Stable = on or off
Pressing PRINT will send the display data.
If Stable is set to On, the indicator will wait for a stable reading before sending the stable data.

Auto Print = not off, Stable = on or off
The indicator will automatically send data based on the settings in the Menu.
If Stable is set to On, only stable values will be sent.
Data sent from the Interface is in standard ASCII format terminated with a [CRLF] (carriage return-line
feed). For the output format please refer to the indicator's instruction manual.
Input
The indicator will respond to various commands sent via the interface adapter. Terminate the
following commands with [CRLF].
Commands
For the full list of commands, please refer to the indicator's instruction manual.
CONFIGURATION
The TD52 indicator connects an Ethernet option board through the RS232 interface. The baud rate
will be 19200. If the option board is not connected, the submenu will not display.
Communication
Ethernet Configuration
Host Name
MAC Address
Port
Version
DHCP
IP Address
Options (bold is default, Red is read only)
OHETHER
00-11-22-33-44-55
9761
1.01
Off, On
169.254.1.1