Precautions - Sony GTK-PG10 Bedienungsanleitung

Resetting the system
If the system doesn't respond and
cannot be operated despite the power
being on, reset the system.
1
Hold down the  (power)
button for more than
9 seconds.
The system will turn off.
2
Press the  (power) button to
turn the system back on.
Note
• If the system doesn't turn back on, consult
your Sony dealer.
• Pairing information is not deleted after
you reset the system.
Restoring the system to the
factory default settings
If the system still does not operate
properly, restore it to the factory
default settings.
1
Press the  (power) button to
turn on the system.
2
Hold down the FUNCTION
PAIRING button and the
MIC – button for more than 3
seconds.
After "RESET" appears on the
display, all user-configured settings,
such as the pairing registration
information, are restored to factory
default settings.

Precautions

On safety
• Completely disconnect the AC power cord
(mains lead) from the wall outlet (mains) if
it is not going to be used for an extended
period of time. When unplugging the unit,
always grip the plug. Never pull the cord
itself.
• Should any solid object or liquid get into
the system, unplug the system, and have
it checked by qualified personnel before
operating it again.
• The AC power cord must be changed only
at the qualified service shop.
On placement
• Do not place the system in an inclined
position or in locations that are extremely
hot, cold, dusty, dirty, or humid or lacking
adequate ventilation, or subject to
vibration, direct sunlight or a bright light.
• Be careful when placing the system on
surfaces that have been specially treated
(for example, wax, oil, polish) as staining
or discoloration of the surface may result.
• Make sure not to splash water on the unit.
This unit is not waterproof.
On heat buildup
• Heat buildup on the system during
operation is normal and is not a cause for
alarm.
• Do not touch the cabinet if it has been
used continuously at a high volume
because the cabinet may have become
hot.
On the speaker system
The built-in speaker system is not
magnetically shielded, and the picture on
nearby TV sets may become magnetically
distorted. In this situation, turn off the TV,
wait 15 to 30 minutes, and turn it back on.
If there is no improvement, move the
system far away from the TV.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad,
scouring powder, or solvent, such as thinner,
benzine, or alcohol.
29
GB