Installation - V2 JEDI-Serie Bedienungsanleitung

INSTALLATION OF MOTOR
ON SECTION BAR
1. Insert the shaft/pinion adapter on the motor shaft.
2. Position the section bar A on the motor:
the shaft/pinion adapter B must fit into the seat on the
section bar. Verify that the section bar fits snuggly
against the motor.
3. Position the two omega brackets C on the section bar
so that they correspond with the holes on the base of
the motor.
4. Fasten the two omega brackets using the 6 x 15
self-threading screws provided D.
m
In case of lack of space, the motor can be
mounted rotated of 90°

INSTALLATION

2.1 Disassemble the door's locking system.
2.2 Measure the door, and at exactly half its height
mark the reference points on the upper crossbeam
and on the ceiling to facilitate positioning of the
guide section bar.
2.3 Fasten the bracket E to the upper crossbeam of the
door using plugs G suitable for the type of wall
(ø minimum 8 mm).
2.4 Hook the section bar A to the bracket using the
hexagonal-head F 6x80 screw with its self-blocking
nut
2.5 Bend the 2 pierced bar at the desired length
2.6 Fix the front pierced bar H to the fixing bracket I in
the section bar using the 8x20 screws L with their
nuts
2.7 Fix the rear pierced bar M to the omega bracket N
using the 8x20 screws L with their nuts
2.8 Following the references previously marked on the
ceiling, locate the fixing points for the bars H and M
and using the screws O suitable for the type of
ceiling (minimum ø 8 mm) anchor the automation
17