FIMAR GYR60 Benutz Und Wartungsanleitung Seite 44

burner nozzle replacement
1 - Loosen the screws and remove the
rear panel.
2 - Unscrew the nozzle (A) and replace it
with the one suited for the gas used.
3 - Reassemble the rear panel and secure
it with the screws.
Heat power adjustment to minimum
GB
METHANE GAS powered appliance
1 - Remove the knob.
2 - Loosen the screw (B) (about 2/3 turn)
and assemble the knob.
3 - Turn on the burner , rotate the knob to
the minimum power position.
4 - Pull out the knob and tighten the screw
(B) until the flame is stable.
5 - Assemble the burner control knob and rotate it to turn it off.
6 - Repeat minimum adjustment on the other burner.
LIQUID PROPANE GAS powered appliance (LPG)
1 - Pull out the knobs.
2 - Fully tighten the minimum adjustment screw (B).
3 - Assemble the knobs.
4 - Turn on the appliance and make sure the flame is stable.
5 - Turning off the appliance
GYROS (GAS POWERED)
B
- 20 -
A
IDM-34605600600.pdf
English language