GGP ITALY 28 Gebrauchsanweisung Seite 28

ASSEMBLY INSTRUCTIONS
to the same degree, adjust the position of the
handlebar, then tighten the screws completely
without over-tightening to lock the handgrip cor-
rectly.
WARNING!
!
Never work with handgrips
that are not correctly fastened or loose.
WARNING!
!
A label with an arrow is
located on the drive, at the level of the fixing
point of the front handlebar. This indicates
the correct position of the handlebar. Do not
alter the position of the handle support of the
front handlebar.
FRONT GUARD (Fig. 3)
WARNING!
!
The guard must be fitted
so as to comply with the correct position of
the line cutting blade and to protect the oper-
ator. Never work without the guard.
The guard must be fitted using the specific
screws and washers provided.
The guard must be the correct type both for the
model of brush cutter and for the cutting tool
used.
When the line head is used, the guard must be
fitted with line-cutting blade. If the guard is not
fitted with a line cutter, the bottom band com-
plete with blade (provided) must be fitted to the
guard. After the bottom band and its guides have
been fitted into the seats, press the band
towards the guard until all the fixing teeth are
engaged (fig. 4).
CUTTING TOOLS
IMPORTANT
other than the 2-line heads or metal disks may
cause premature wear or damage to the brush
cutter.
METAL DISKS (Fig. 5)
WARNING!
!
Put on a pair of protective
gloves before touching the metal disk.
a) Fit the cylindrical bushing (A), the grooved
ring nut (B), the metal disk (C), the ring nut (D),
the fixed cover (E) and the washer (F) to the
head shaft, followed by the hexagon fixing
The use of cutting tools
nut (G), turning it counter-clockwise.
b) For safe blocking, the spindle must be pre-
vented from rotating: insert the steel rod (H)
(provided) into the hole on the side of the ring
nut B, turn the tool slowly until the steel rod
enters the hole on the side of the head, to
block tool rotation. Tighten the nut and
remove the steel rod from the hole.
LINE HEAD (Fig. 6)
a) Fit the cylindrical bushing (A) and the grooved
ring nut (B) to the head shaft, then tighten the
line head (C) counter-clockwise (the thread is
left-hand).
b) For safe blocking, the spindle must be pre-
vented from rotating: fit the steel rod (H) (pro-
vided) into the hole on the side of the ring nut
B, turn the tool slowly until the steel rod enters
the hold on the side of the head, to block tool
rotation.
MOUNTING ROAD (Models with separate rod
– Fig. 6/1)
Line up the slot (A) on the joint (B) with the raised
notch (C) on the lower part of the rod (D).
Pull out the stop pin (E) and push the lower part
of the rod (D) right down until the stop pin E)
slots in the hole (F) on the rod.
This is easier to do if you rotate the bottom of the
rod (D) slightly in both directions. The pin (E) is in
place when it is completely lodged in the hole.
Lastly, tighten the knob (G) securely.
HARNESS (Fig. 7)
The brush cutter is provided with a single strap
harness. Pass the strap over your left shoulder
towards your right side. Then attach the snap
hook to the supporting coupling provided on the
drive tube of the brush cutter.
WARNING!
!
In order to work more effi-
ciently and safely, adjust the straps accord-
ing to your height and build.
27