Interface Installation - OHAUS Scout STX Serie Bedienungsanleitung

RS232 Interface
INTRODUCTION
This Interface Kit is for use with OHAUS Scout STX, SPX, SKX, SJX series and
PJX series products.

INTERFACE INSTALLATION

Install the Interface module on the mini DIN port (round connector) located at the
rear side of the balance as shown. During this process, please make sure the
balance is powered off.
Notes:
Please make sure the small triangle mark (▲) on the round connector is at
the bottom and then plug in.
The appearance of your model may be different.
SETUP
A) The OHAUS Interface is preset to communicate using the following settings:
9600 baud, 8 bit, no parity, no handshake. Determine the RS232 parameters
required for the printer or computer that is to be connected. See computer or
printer documentation if assistance is required. If the parameters do not match,
it will be necessary to change either the balance settings, or the computer /
printer settings.
B) Upon installation of the interface, the balance will recognize the RS232
Interface and add relevant items to the menu. Configure the balance to the
desired RS232 and printing parameters; refer to the balance Instruction Manual
for assistance in using the menus.
EN-1
Mini DIN port
(Round connector)