Interface Installation - OHAUS Scout Bedienungsanleitung

GlobalScientificSupply
www.
Ethernet Interface
INTRODUCTION
This Interface Kit is for use with Ohaus Scout STX, SPX, SKX and SJX series
products.

INTERFACE INSTALLATION

Install the Interface module on the mini DIN port (round connector) located at the
rear side of the balance as shown. During this process, please make sure the
balance is powered off.
Notes:

Please make sure the small triangle mark (▲) on the round connector is at
the bottom and then plug in.

The appearance of your model may be different.
SETUP
Upon installation, the balance will recognize the Ethernet Interface Kit and add the
following items to the menu structure. Configure the balance to the desired Ethernet
and printing parameters.
CAUTION:
Invalid or incorrect Ethernet parameters may impact your network
system or lose network connectivity. Please check with your network administrator
before use.
For SPX, SKX and SJX Balances:
Upon installation, the balance will show [
PRINT
Reset: no, yes
Stable: off, on
A.Print: off
On.stable (->Load, Load.Zero)
interval (-> 1....3600)
accept
continuous
Content: Result (-> off, on)
Gross (-> off, on)
Net (-> off, on)
Tare (-> off, on)
Header (-> off, on)
Footer (-> off, on)
Mode (-> off, on)
Unit (-> off, on)
Info (-> off, on)
Layout: Format (->Single, Multi)
Feed (->Line, 4 Lines, Form)
End Print: Exit menu
Note: Items with bold font are default settings.
.com
(Round connector)
E.t.h.n.e.t
] during the power sequence.
Ethrnt
IP Adr
End
GLOBAL SCIENTIFIC SUPPLY
The Laboratory Supply Company!
EN-1
Mini DIN port
info@GlobalScientificSupply.com