Installation - HQ Power VDP900HZ Bedienungsanleitung

• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
• Do not add oils, perfume or any other liquid in the smoke liquid.
• The installation has to be approved by an expert before the device is taken into service.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.

4. Installation

• Remove all packing material from the shipping box. Check that all foam and plastic padding is removed.
• Clean the spray nozzle and make sure nothing is obstructing the output.
• Place the VDL900HZ horizontally on a flat surface. Remove the liquid tank cap.
• Pour high quality smoke liquid (VDLHLH5) into the tank, being careful not to exceed the maximum fluid level. Do
not overfill. Place the cap back on the liquid tank and tighten.
• Connect the remote control into the slot at the back of the device.
5. Use
a) The Device
• Plug the remote control into the slot at the back of the device. Plug the device into the mains using the power
cord.
• Turn on the power switch located at the back of the device.
• The red light on the remote control will light up.
• The device must warm up. The period depends on the conditions but should not take more than 10 minutes.
• The green light on the remote control will go up once the machine is ready to operate (see "The Remote
Control").
b) The Remote Control (fig. 1)
1. Power LED
2. Smoke output every x minutes (max. 30 minutes)
3. Output volume
4. Fixed time open LED
5. Output LED
6. Successive spraying for x seconds (max. 15 seconds)
7. Heated over LED
8. Spray button
6. Notes
The VDP900HZ does not feature an automatic stop function when running out of fluid; the
pump will continue working. Always monitor the tank fluid level during operation as the device
can suffer damage when run without fluid!
• If you experience low output, mechanical noise or no output at all, unplug the device immediately. Check the fluid
level, the external fuse, the remote control and the power cord. If all appears to be working properly, plug in the
unit again. If the device will not function after 30 seconds, discontinue operation to avoid permanent damage.
Return the device to your dealer. Remember to drain the tank before transporting the unit.
• Using the device will produce water drops at the nozzle. This is perfectly normal.
• A little smoke may continue to escape from the nozzle after operation.
VDP900HZ_v2 3 VELLEMAN