Positioning - Ugur UPR 1 Bedienungsanleitung

C- INSTALLATION OF YOUR PASTRY DISPLAY

Positioning

Possible placement positions:
1- In a way that the back side alone is opposite to the wall; be careful that there is a gap of 150 mm (15 cm) be-
tween the wall and your product. (Picture 7)
2- In a way that is place to a corner; when you place it to a corner, leave a gap of 150 mm (15 cm) behind. You can
lean the side, corresponding to the corner, to the wall.
The most important point to be considered in all cases of product placement is not to obstruct ventilation of the
compressor assembly.
Without exposing your product to any slope, place and operate it in a manner that it is on its feet or wheels.
(Picture 8)
The freer the compressor assembly ventilation is, the better the device will run.
EN
Resim 7 Resim 8
36