Internal Setup And Connections - Korg HT-10 Bedienungsanleitung

Internal Setup and Connections

Connecting the Power
Start with the HT-10 turned OFF. Connect the
supplied AC adapter to the power cord. Insert
the DC plug end into the DC12V jack on the rear
panel. Next, plug the power cord into an AC
outlet.
Be sure to use the supplied AC adapter. Us-
ing other AC adapters may cause the unit to
malfunction.
Be sure to plug the unit into an AC outlet of
an appropriate voltage.
Turning the HT-10 ON
Rotate the VOLUME knob toward the right to
turn on the power. (Figure 2)
The power LED will light up.
To turn the power off, turn the VOLUME knob
toward the left until it reaches the "STANDBY"
position. The power LED will go dark.
There will be a "click" when you turn the power
on or off.
Auto power off function
This feature automatically turns off the HT-
10 when 30 minutes have passed without a key
pressed in the keyboard or without a function
setting specified using the keyboard.
When this function is enabled, the HT-10 will be automatically turned off, even if
the [VOLUME] knob had been used to turn it on. To turn on the HT-10, first turn
it off by fully turning the [VOLUME] knob counterclockwise to the "STANDBY"
position, and then turn the [VOLUME] knob to turn it on again.
Adjusting the volume
Rotate the VOLUME knob to adjust the volume. (Figure 2)
The VOLUME knob controls the output level of the headphone jacks.
(Figure 1)
Figure 1
DC plug
Figure 2
Softer
On
Power LED Headphone Jacks
Operation panel
Bottom panel
of piano
Power cable
for AC adapter
AC adapter
to an AC outlet
Louder
15