AEG DD8694-M Bedienungsanleitung Seite 12

This filter cannot be washed or regenerated. It must be replaced when the c appears on the
display or at least once every 4 months. The filter saturation alarm has to be activated already
before.
Activation of the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation
or at a later date.
• Press and hold button e (Delay) for 5 seconds, until confirmation appears on the display:
• C flashes twice – Activated Charcoal Filter saturation alarm ACTIVATED.
• C flashes once – Activated Charcoal Filter saturation alarm DEACTIVATED.
RePLAcINg THe cHARcOAL FILTeR
Reset of the alarm signal
• Switch off the hood and the lighting.
• Press the D-key until the display is unlit.
Replacing of the filter
• Open the comfort panels pulling them downwards.
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing
the fixing hooks
• Fit the new filter and fasten it in its correct posi-
tion.
• Put the metal grease filters in their seats.
• Close the comfort panels.
LIgHT RePLAceMeNT
20 W halogen light.
• Remove the 2 screws fixing the Lighting support,
and pull it out of from the Hood.
• Extract the lamp from the Support
• Replace with another of the same type, making
sure that the two pins are properly inserted in the
lamp holder socket holes.
• Refit the Support, fixing it in place with the two
screws removed as above.
charcoal filter (recycling version)
Lighting
12
MAINTENANCE