The Guarantee On The Product Will Not Be Applied In The Following Cases - maniquick mq Perfect Gebrauchsanleitung

EN
9. CONDITIONS FOR SERVICE UNDER GUARANTEE
1. SANICO Srl guarantees the absence of faults and mechanical defects and the complete-
ness of the product when it is sold.
2. Repairs can be done only at Service Centres authorized by SANICO Srl or by the Authorized
Distributor in the country where you have purchased the appliance.
3. The duration of the period of guarantee on the materials and on manufacturing and operat-
ing defects is 5 years with effect from the date of sale, subject to all the conditions for
the Purchaser shown in the Instructions for use. The obligations of guarantee do not cover
expendable materials: electrode cups, elastic bands, power supply cables etc..
4. Complaints relative to the product must be presented directly to the authorized service
centre. The service centre, on the basis of an agreement with the Vendor, is competent to
establish the cause and nature of the fault. The product will be replaced only if it cannot
be repaired.
5. The owner will provide to deliver the product to the after-sales service center, as per the
delivery instructions that can be requested by e-mail: info@maniquick.com.
6. The time necessary for the repair under guarantee will be subject to the degree of serious-
ness of the fault.
7. The responsibility of SANICO Srl under these conditions of guarantee will be limited to the
amount paid by the Purchaser for the product in question.

The guarantee on the product will not be applied in the following cases

• certificate of guarantee filled in incorrectly or falsified; serial number (if applicable for the
specific product) damaged or removed;
• absence of commercial and financial documents (cash receipt, delivery note) proving the
purchase;
• opening or repair of the product by the Purchaser or by an unauthorized Service Centre;
• defects following failure by the Purchaser to observe the rules for use, storage and trans-
port of the product shown in the relative technical and regulations documentation, in
which case the regulations of the aforementioned documentation which have been in-
fringed must be specified;
68