Areas Of Use - Stiga PARK UNLIMITED Gebrauchsanweisung

2.4.10 Power take-off (4, 5, 6:K)
A lever for engaging and disengaging the power
take-off for operating front-mounted accessories.
Two positions:
1. Lever in forward position – power take-
off disengaged.
2. Lever in backward position - power
take-off engaged.
2.4.11 Hour meter (2:P)
Indicates the number of working hours. Only
works when the engine is running.
2.4.12 Cutting height adjustment
(6:J)(Excellent)
The machine is equipped with a control for using
the cutting deck with electrical cutting height ad-
justment.
The switch is used to adjust the cutting
height in continuously variable positions.
The cutting deck is connected to the contact (2:Q).
2.4.13Clutch release lever
A lever for disengaging the variable transmission.
2WD is equipped with a lever, connected to the
rear axle. See (7:R).
The lever enables the machine to be moved by
hand without the help of the engine. Two positions:
1. Lever in the inner position –
transmission engaged for normal
operation.
2. Lever in the outer position –
transmission disengaged. The
machine can be moved by hand.
The machine may not be towed over long distances
or at high speeds. The transmission could be dam-
aged.
2.4.14 Seat (1:S)
The seat can be folded and adjusted front-
rear. The seat can be adjusted as follows:
1. Move the control lever (1:T) upwards.
2. Set the seat to the desired position.
3. Release the control lever (1:S) to lock
the seat.
The seat is equipped with a safety switch that is
connected to the machine's safety system. This
means that certain dangerous activities are not pos-
sible when there is nobody sitting on the seat. Also
see 4.4.2.
ENGLISH
2.4.15 Engine casing (8:U)
In order to access the fuel cock, battery
and engine, the machine has an engine
casing that can be opened. The engine cas-
ing is locked with a rubber strap.
The engine casing is opened as follows:
1. Undo the rubber strap (8:V) at the front edge of
the casing.
2. Carefully lift the engine casing back.
Close in the reverse order.
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.

3 AREAS OF USE

The machine may only be used for the following
tasks using the genuine STIGA accessories stated.
Work
Mowing
Sweeping
Snow clearance
Grass clipping and
leaf collection
Grass and leaf
transport
Weeding on gravel
paths
Lawn edge trim-
ming
Moss scarification Using moss scarifier.
The maximum vertical load on the towing hitch
must not exceed 100 N.
EN
Accessories, STIGA genuine
Unlimited, President:
Using mowing decks:
95 C och 105 C, and with flail
mower.
Power:
Using mowing decks:
95 C, 105 C, 121 M, and with
flail mower.
Excellent:
Using mowing decks:
95 C, 105 C, 121 M, 121 M El,
110 Combi Pro, 110 Combi Pro
El, 125 Combi Pro, 125 Combi
Pro El and with flail mower.
Using brush unit or collector
brush unit. The use of a dust
guard is recommended with the
first option.
Using snow blade or snow
thrower Snow chains and frame
weights are recommended.
Using towed collector 30" or
42". Pro Cart.
Using dump cart Pro or Combi.
Using front-mounted hoe.
Using edge trimmer.
55