Placing And Removing Discs - Panasonic CF-VDRRT3W Bedienungsanleitung

Placing and Removing Discs

This drive's disc cover is designed to be opened electrically. When power is not supplied
to the drive, the disc cover will not open even when the open button is pressed.
3
2
4
Title-side up
CAUTION
Set the disc correctly. Otherwise, it may spin off and be damaged as a result.
If power is not supplied to the drive, slide the emergency open lever.
( page 6 (E)).
If you want to remove discs when a program is being used, exit the program, and
check that the drive's indicator does not light up in orange.
NOTE
Since the disc cover is locked while a B's CLiP formatted disc is being used,
select [Eject] from the icon displayed on the taskbar to release the lock.
While data is being written, the indicator lights up and the disc cover is locked:
therefore, the disc cover cannot be opened during data writing.
1 Turn on the drive's power.
The drive's on/off power operations are
coupled to the computer so that when
the computer is turned on or off, the
drive will be automatically turned on or
off.
2 Press the open button.
The disc cover opens slightly.
(The disc cover can also be opened by
selecting [Eject] from the application
software.)
3 Open the disc cover fully.
4 Insert the disc.
Use your fingers to press the part near
the disc center down until the disc is
secured in place.
<Removing the disc>
Check that the disc has stopped turning
completely, and remove it by pressing
down on its center part while clasping
its outer edge and lifting it free.
5 Close the disc cover.
E
13