Using The Refrigerator; Energy Saving Tips; Connecting The Refrigerator - Dometic DW6 Bedienungsanleitung

Using the refrigerator

6 Using the refrigerator
!
WARNING! Fire hazard!
• When positioning the device, ensure the supply cord is not trapped or damaged.
• Do not locate multiple portable socket-outlets or portable power supplies at the
rear of the device.
!
NOTICE! Damage hazard
The lamp can only be replaced by the manufacturer, service agent or similarly qualified
person to avoid hazard.
I
NOTE
Before starting your new refrigerator for the first time, you should clean it inside and
outside with a damp cloth for hygienic reasons (see chapter "Cleaning and mainte-
nance" on page 14).
6.1

Energy saving tips

• Choose a well ventilated location which is protected from direct sunlight.
• Use the ECO mode of the refrigerator if you want to set a higher energy efficiency and a limited
cooling capacity of the refrigerator.
• Do not open the refrigerator more often than necessary.
• Do not leave the door open for longer than necessary.
6.2 Setting up the refrigerator
➤ Make sure that the location is able to support the weight of the refrigerator as well as its
maximum load.
➤ Position the refrigerator horizontally.
➤ Open the door of the refrigerator.
➤ Slide the condensation tray at the bottom of the refrigerator into the corresponding holder
(fig. 5, page 4).
➤ Put the interior racks in the refrigerator so that they are on the pre-assembled side rails (fig. 6,
page 4).
➤ Close the door of the refrigerator.
6.3

Connecting the refrigerator

D
DANGER!
Never handle plugs and switches if you have wet hands.
➤ Before starting up the refrigerator for the first time, check whether the operating voltage and the
mains voltage match (see type plate).
12
DW6
EN