Inserting Slides - Silvercrest SND 3600 D3 Bedienungsanleitung

Inserting slides

♦ Insert slides the right way round into the shaft provided on the
slide magazine
can be added to the magazine.
♦ Push the slide magazine
viewing window at the front. Ensure that the triangle marking is
at the front and visible (see figure 2).
Use the pusher on the side of the slide magazine
slides in the shaft individually into the scanner.
♦ To do this, first slide the pusher away from the scanner as far
as the stop. Afterwards, move the pusher carefully towards the
scanner.
NOTE
► This pushes any slide that is in the scanner out of the device
and a new slide is pushed into the viewing range of the
scanner.
► Make sure that you push the new slide into the scanner
slowly. If you push too quickly, the slide could slip past the
viewing range of the scanner.
♦ When you have finished scanning slides, remove the slide maga-
zine from the slot
6
Remove the last slide from below from out of the slide magazine
viewing window
SND 3600 D3
. Around 10–12 slides (depending on size)
6
into the slot
6
.
4
.
6
on the right with the
4
to push the
6
GB │ MT │ 89 ■