Leica M Monochrom Anleitung Seite 147

procedure
1. Press the SET button (1.21).
• The corresponding sub­menu appears in the
monitor (1.32).
notes:
• The setting process can be cancelled at any time,
either by pressing the PLAY button (1.26) to return to
normal review mode or by tapping the shutter release
button (1.19) to switch to picture mode.
• The following
controls and their functions are not available during
the entire setting process: DELETE
(1.22) buttons
The subsequent procedure is controlled by the menu,
i.e. essentially as described in the "Menu control"
section (see p. 26). After specifying the relevant menu
display, this is done using the setting dial (1.29), the
direction buttons (1.30) and the
2. The first step is to decide
• whether you want to protect individual pictures
Protect Single
• simultaneously protect all pictures
• whether you want to clear the existing protection
for individual pictures
• for all pictures
note:
The following functions cannot be performed and the
menu text appears in white instead of black to indicate
this:
– Protecting a picture that is already protected, or if all
pictures are already protected.
– Clearing the protection for a picture that is already
(1.24) and INFO
unprotected, or if no pictures are already protected.
SET button (1.21).
, or
, or
Protect All
, or
Unprotect Single
Unprotect All .
dIspLAys AFTEr proTECTIon /
CLEArIng proTECTIon
After exiting the menu, the original monitor display
appears again, with the corresponding symbol
(3.2.1/3.3.3) for protected pictures.
note:
The symbol also appears if a picture that is already
protected is opened.
145