Rear View; Optional Drive And Installation - Pioneer DRM-1004 Bedienungsanleitung

PANEL FACILITIES

REAR VIEW

3
1
2

OPTIONAL DRIVE AND INSTALLATION

The Optional Drive (Sold Separately)
DVD-ROM drive unit [DVD-D302]
CD-R drive unit [DR-R102]
With this changer, customers have to separately purchase the optional drive that matches their specifications. The bay where the optional drive
is installed is on the rear of the machine where up to four can be installed. (Because the maximum number that can be installed varies depending
on the drive, refer to the instruction manual for the driver you are using for details.)
For the latest information about the types and model numbers of the drives that are compatible with this machine, inquire at the dealer where
you purchased it or at our home page.
Caution: Installing the optional drive
Because installing an optional drive requires considerable specialized expertise and must be done safely, our service department will install it
for you. Please inquire at the dealer where you purchased the machine for details.
8
<DRC1129>
En
120V
230V
100V
SIGNAL
GND
1 SCSI connector
2 Function switches for Changer
1: When components are connected through the
SCSI connection, the terminator should be
attached to the last component in the
connection. In case this Changer is the last
ON
OFF
component, set this switch to the ON position.
SCSI TERMINATOR
2: Reserved
7 3 SCSI ID switch for Changer
4
Assign the ID number of the machine.
0
6
Assign a unique SCSI ID to each unit when several units are
used on a same SCSI bus (in a daisy chain).
Be careful to never assign the same number to more than one
component. If an identical number is assigned to more than
5
one component, system operation will be impossible.
NOTE:
When setting the SCSI IDs, be careful not to leave the pointer
arrow of the SCSI ID switch between two figures; be sure to
set the switch so that the arrow points a single figure.
4
4 Drive 1 installation location
5 Drive 2 installation location
8
6 Drive 3 installation location
7 Drive 4 installation location
9
8 Ground (GND) terminal
9 VOLTAGE SELECTOR
0
Refer to page 4.
0
AC inlet