Electrical Connection - Edesa LE21S Installations- Und Bedienungsanleitungen

The hose must run
b
between the wall and
the bottom space at
the back of the dis-
hwasher (b1) so that
it is not squashed or
overstretched.
There should be a fixed
water outlet drain at a dis-
tance of between 40 and
100 cm from the floor.
Make sure that the outlet
pipe is not too rigid, bent
or squashed.
I M P O R TA N T
It is very important for the bend pipe of the outlet hose is located securely in water outlet
so that it cannot disconnet.
3

ELECTRICAL CONNECTION

Please refer to the speci-
fication label on the top
edge of the door before
making the electrical con-
nections. Make sure that
the power voltage con-
nected to the plug socket
is as shown on the label.
I M P O R TA N T
It is very important for the dishwasher to be connected to an earthed plug
socket. The electrical installation, plug, socket, fuses or circuit breaker and
meter must be capable of the maximum power shown on the specifications
label.
If the power cable is damaged, it must be replaced exclusively by the
manufacturers, after-sales service (TAS) or authorised personnel.
b1
max.
100 cm
min.
40 cm
English
b2
If your dishwasher has a
hot water inlet, connect
the pipe to the hot water
tap. In this case, the maxi-
mum temperature must
not exceed 60ºC. Bear in
mind that this type of
water supply may affect
the washing and drying
capacity of the appliance.
55