Troubleshooting - Edesa LE21S Installations- Und Bedienungsanleitungen

DISHWASHER
If you find a problem
when using your dishwas-
her, you will probably be
able to solve it by consul-
ting the following section.
1
TECHNICAL OR FUNCTIONAL PROBLEMS
• Why won't the dishwasher start?
This may be because:
– There is no power.
– It isn't plugged in correctly.
– The power fuses have blown.
– The dishwasher is not connected to the mains.
– You haven't pressed the On/Off button (the pilot light for this button must be on continuously).
– The dishwasher door is not closed correctly.
– You have not pressed the Start button.
• The dishwasher starts up but no water comes into the appliance
This may be because:
– There is no water supply.
– The stop tap is off.
The water inlet electrovalve filter is blocked.
• The water does not drain off and stays in the dishwasher
This may be because:
– The drain is blocked or badly fitted.
– The drainage pipe is blocked or kinked.
– The filters are blocked.
– The selected programme has not ended. Wait until it finishes.
• The low salt level pilot light does not go off
This may be because:
– A low salt level. Add salt and stir with a spoon.
– The water hardness is below 7DH, which means that salt is not necessary. In this case,
the light will always be on.
If this is not so, please
contact the TECHNI-
CAL ASSISTANCE
SERVICE and be ready
to provide as much infor-
mation as possible.

TROUBLESHOOTING