Control Panel; Power Indicator - Sony HDLA1500 Handbuch

Control Panel

a POWER indicator
b Video signal select buttons
c RET 1 button and selector knob
d CURSOR 1, 2, and 3 buttons
e CURSOR STORE button
f CURSOR ON button
g H-POSI control
h V-POSI control
i WIDTH control
j HEIGHT control
k FILTER LOCAL button
l Filter selectors
a POWER indicator
This indicator lights up or goes dark as follows to indicate
the power supply status of the camera:
Green: Power is being supplied to the camera.
Red: Power is being supplied to the camera, but the CAM
PW button of the MSU-900/950 Master Setup Unit or
RCP-700/900-series Remote Control Panel is set to
OFF.
Yellow: Power is being supplied to the camera, but the VF
PW button of the MSU-900/950 Master Setup Unit or
RCP-700/900-series Remote Control Panel is set to
OFF, and power is not being supplied to the
viewfinder.
Off: Power is not being supplied to the camera.
b Video signal select buttons
Select the video output signal (R, G, or B) to the
viewfinder.
The R, G, and B buttons may be pressed individually or in
combination. The signal corresponding to each pressed
button will be output. When two buttons are pressed, the
output will consist of those two signals mixed together.
When all three buttons are pressed, the output to the
viewfinder will be the Y signal.
POWER
R G B
RET 1 RET 2
2 3 4 2 3 4
1 1
VF DTL
CURSOR
OFF ON
1 2 3 CALL
STORE
MIX VF
VF SCAN
ON
ON
OFF
SCREEN SIZE
MARKER MARKER
H-POSI V-POSI
ON
ON
OFF
OFF
DISPLAY UP TALLY
ON
OFF
WIDTH HEIGHT
MENU
CANCEL ENTER
FILTER
LOCAL
2 3 4 B C D
1 5 A E
ND CC
When no buttons is pressed, the output will be a color
signal if the viewfinder is a color model, and it will be the
Y signal if the viewfinder is a monochrome model.
The video output to the monitor connected to the TEST
OUT connector of the camera will also depend on the
setting of these buttons (however, this output is in
monochrome in all situations).
c RET 1 button and selector knob
You may select from among the four return signals from
the CCU, using the selector knob.
By pressing the button, you can view the return video
signal selected by the selector knob, on the viewfinder
screen. Pressing the button again will switch the
viewfinder screen display and monitor output back to the
camera's video signal.
d CURSOR (cursor memory) 1, 2, and 3 buttons
Used to store the size and position of the box cursor to be
displayed on the viewfinder screen.
Three different box cursor settings can be stored in
memory using buttons 1, 2, and 3. Pressing one of these
buttons will cause a cursor of the respective stored size and
position to be displayed.
m Back tally lamp
n RET 2 button and
selector knob
o VF DTL switch
p CALL button
q VF DTL control
r VF SCAN switch
16:9
s MIX VF switch
4:3
t SCREEN SIZE MARKER
switch
u MARKER switch
v UP TALLY switch
ON
OFF w DISPLAY switch
x MENU switch and control
ASSIGN-
ABLE
y ASSIGNABLE switch
Locations and Functions of Parts
35