Bellelli Giotto Bedienungsanleitung Seite 13

How to free the child from the seat
Press the adjuster (E) and at the same time pull
both the harness straps (I) to slacken them
(fig. 17).
Press the red button on the buckle (G) to open it.
Take off the straps and clear them from the child.
Groups 2 and 3 (from 15 to 36 kg)
Warning: remove the child seat harness (I)
before using for groups 2 or 3.
How to remove the car seat harness
Release both harness straps (I) from the metal yolk
(J) and unthread them from the backrest (fig. 18).
Unthread the padding fixture plates (K) from the
backrest (fig. 19).
Turn the child seat over and completely
unthread the straps (I) (fig. 20).
Pass the metal clip (L) of the buckle through the
hole in the seat and unthread the buckle (G)
from the child seat (fig. 21).
How to position the child in the seat
Position the child seat on the car seat so that it
is fully supported on the seat and backrest.
Warning: The car seat belt routing positions are
marked in red. Do not route the car seat belt in
positions other than those indicated.
Position the diagonal section of the car seat belt
over the child's chest and pass it under the seat
armrest on the opposite side to the retractor (fig.
22).
Insert it into the belt guide (B) (fig. 23).
Pass the lap section of the car seat belt under
the two armrests of the seat (fig. 24).
Tension the car seat belt well, check that there
are no twists and that it runs smoothly under the
armrests of the child seat.
Close the car seat belt (fig. 25).
Warning: During the journey periodically check
that the child has not freed itself from the child
seat.
How to free the child from the seat
Release the car seat belt, unthread it from the
child seat and allow it to retract.
Maintenance
Take the covers off completely for washing.
Follow the washing instructions given on the
label attached to the fabric.
Wash plastic parts using warm water and soap.
Do not use aggressive cleaning agents.
Warning: The covers are an integral part of the
child seat: the seat must not be used without the
covers.
The covers must only be replaced with original
replacement covers.
Guarantee
The conditions of the guarantee can be seen on
our web site: www.bellelli.com.
11
EN