Operation; Before The First Use; Fill In Ground Coffee; Fill Water - Silvercrest KH 1112 Bedienungsanleitung

Operation

Before the First Use

IMPORTANT!
• Never fill the water tank with a volume of mains
water greater than 10 large or 15 small cups of
water.
Never fill the water tank with a volume of mains
water less than 2 large or 3 small cups of water.
Otherwise the coffee maker could be damaged.
• Disconnect the coffee maker from the power sup-
ply immediately after use. The coffee maker is
only fully currentless when you pull the plug out
of the wall socket.
• Only pour tap water into the water container.
Otherwise you may damage the coffee maker.
• open the glass coffee-pot
contaier.
• Carefully rinse the water container and the glass
u
coffee-pot with tap water.
u
• Fill the glass jug
maximum of 10 large or 15 small cups.
• Pour all the tap water into the water container
(fig.C).
• Place the empty glass coffee-pot
y
hotplate .
• Switch the coffee maker on and wait until the
coffee-making procedure has finished.
• Empty the glass coffee-pot
• Switch the coffee maker off by pressing the
mains switch again
goes out.
Then you can use the coffee maker to make fresh
coffee.
u
and the water
with mains water for a
u
onto the
u
.
t
, until the power on light

Fill in ground coffee

• Swing out the filter holder
• Place an opened size 4 paper filter into the filter
q
holder . (First fold the bottom filter paper edge
over)
• Fill the ground coffee into the paper filter.
Allow approx. one level coffee measure per
small cup of ground coffee. For large cups, al-
low approx. one heaped coffee measure per
cup. If the coffee is too strong, you can reduce
the amount of ground coffee per cup to taste.
• Close the filter holder

Fill water

• Open the water container lid
• Fill the glass coffee-pot
• Pour the tap water for the amount of coffee
required into the water container (fig.C).
• Close the water container lid

Switching on and off

• When you wish to switch the coffee machine on,
press down on the power switch
power lamp glows blue.
• If you wish to switch off the coffee maker, press
the power switch
out.
• Then pull the power plug out of the wallsocket.

Wind up the cord

• Push the cord into the cord compatment on the
back of the machine (fig.B).
• If necessary, push the metal contact
of the plug into the holes above the cord com-
partment.
- 28 -
q
(fig. D).
q
.
i
.
u
with tap water.
i
.
t
until the
t
until the pilot lamp goes