Safety Considerations - HEIDENHAIN ND 1400 QUADRA-CHEK Kurzanleitung

ND 1400 QUADRA-CHEK
Setup
For detailed description and latest document version, see www.heidenhain.de
Before Power up
Electrical connection
Line voltage: 100 V~ to 240 V~
(–15 % to +10 %)
Line frequency: 47 Hz to 63 Hz
Line fuse: T1600 mA, 250 V
5 x 20 mm
Power connector wiring
L: Line voltage (brown)
N: Neutral (blue)
Earth ground (yellow/green)
Danger of electrical shock!
• Do not open the enclosure.
• Never use 3-wire to 2-wire adapters
or allow the ground connection to
the ND 1400 to be interrupted or
disconnected.
Caution
Changes to the power cable may be
made only by an electrical technician.
Caution
Do not connect encoders or other
equipment to the ND 1400 when the
power is on.

Safety Considerations

General accepted safety precautions
must be followed when operating the
ND 1400. Failure to observe these
precautions could result in damage to
the equipment, or injury to personnel.
It is understood that safety rules within
individual companies vary. If a conflict
exists between the material contained
in this guide and the rules of a company
using this system, the more stringent
rules should take precedence.
Controls and Displays
A LCD screen
B Command keys: Control
measurement
C Numeric keypad: Enter numeric
data
D Fast track keys: Programmable
for frequently used functions
E Send key: Transmit
measurement data to PC, USB
printer or USB drive
F LCD on/off key: Turn LCD on or
off or delete features from the
feature list.
Connections rear side
1 Power switch
2 Power connection with fuse
3 Ground (protective ground)
4 Encoder inputs, X, Y, Z axis for
linear encoders Q axis for rotary
encoder. Interface specified at
the time of purchase.
5 RS-232-C interface for PC
connection. RS-232 cable must
not include crossovers.
6 Probe connector for
HEIDENHAIN 15 pin universal
touch probe sensor.
7 Probe connector for 5-pin touch
probe sensor.
8 Remote accessory interface
RJ-45 for optional foot switch
accessory.
9 Unused
Connections side view
10 Audio out for 3,5 mm
headphone / speaker jack,
monaural, 8 Ohm
11 USB type A interface for printer
or data storage
12 Unused
Mounting
The ND 1400 is secured to the swivel
slots of the mounting stand or arm
mount by a shoulder screw, a cap
screw mount is shown with associated
washers.
Very important
Please note
For your information
DR. JOHANNES HEIDENHAIN GmbH
Dr.-Johannes-Heidenhain-Straße 5
83301 Traunreut, Germany
{ +49 8669 31-0
| +49 8669 5061
E-mail: info@heidenhain.de
www.heidenhain.de
English
1