!!!Check our website to see if an update version of this
Pairing extra Headsets
Important: Pairing must be completed while Base lights are flashing. If
lights stop flashing before pairing is complete you must repeat the process.
To pair Base and Headset ensure batteries are fully charged and the Base
is connected to mains power. Proceed as follows:
Base: Switch power off at Base.
Press and hold down 'CH' button,
switch power back on, continue to
hold 'CH' button until both lights on
the front start flashing.
Base is ready for pairing.
User Guide is available.!!!
2
Headset: Press and hold down the '-
' (minus) button.
While holding the button, open arms
and the green indicator lights up.
When light starts flashing pairing is
complete.